Instructions for Filling
Out CF7512 “IT” Zone
Removal
General
instructions for all importers
and carriers in preparing Customs
Form 7512 are found in Customs
Directive 3240-36 and superseding
issuances. The following instructions
should be noted by zone users
filing entry for transportation
from a foreign-trade zone:
1. Upper Left Hand Corner -
After "Entry No.",
show lot number, if merchandise
controlled under lot system.
2. Upper Right Hand Corner -
Be sure to show class of
entry as "IT".
3. In-bond via - Usually,
only the bonded carrier's
name would appear here. However,
if the merchandise is to
be carted to another location
for delivery to the bonded
carrier, show also the name
and CHL number of the cartman.
In this case, the reverse
side of Customs Form 7512
may be filled out in lieu
of Customs Form 6043, as
noted in Appendix G. Also,
after the name of the bonded
carrier, show in parentheses
the custodial bond number
and IR number to be obligated
for transportation.
4. Goods now at -
Show "FTZ" along
with the applicable zone
and site number, and if applicable,
the location where the goods
are held.
5. 0pen space in middle
of form - Show here remarks
required in Sec. 146.62(b)(2)
CR and, where applicable,
Sections 146.66(b), and 146.70(c)
and (d) CR. Show also here
any discrepancies noted by
the carrier upon receipt,
with concurrences and seal
notations.
6. To the Inspector or
Warehouse Officer - The
signature of the Customs
officer in this space usually
constitutes the permit for
removal of the merchandise
from the zone for transportation.
However, in rare cases, a
Customs officer may physically
supervise the transfer from
the zone, in which case,
the removal permit will be
shown in the lower left hand
corner in the space beginning
with "Delivered to the
carrier..."
7. Received from the Port
Director - The dated
signature of the carrier
here relieves the zone operator
from responsibility for the
merchandise and transfers
the responsibility to the
carrier. Any discrepancies
should be noted in the open
space in the middle of the
form.
8. Port director of Customs
at - must show the Port
name as well as the Port
code.
|
